Favorites|Message|Contact Us|Chinese

Hello, welcome to visit our official website!

Jiangyin Lijian Diamond Abrasive Tools CO.,LTD.

Jiangyin Lijian Diamond Abrasive Tools CO.,LTD.

Contact Us

Hotline:0510-86535918
Tel:0086-0510-86535918

Fax:0086-0510-86535886

Email:lijiandiamondtool@163.com

Address:No.#254 Huandong Road Huangtang Xuxiake Town,Jiangyin City,Jiangsu Province,China

Location:Home » News Center » Industry News

A common problem analysis aluminum cutter carbide saw blade

Visits:Dates:2016/8/19 13:38:38

A, about the abnormal sound problem analysis and processing scheme

1, aluminum cutting machine is special carbide saw blade if found to have abnormal sound, probably because of the external factors or excessive force to cause the people saw a slight deformation, triggering a warning.

Treatment plan:

The carbide saw blade for correction processing again.

2, aluminum cutting machine spindle clearance is too large, produce a beating or deflection.

Treatment plan:

Stop equipment, check to see if installed correctly.

3, aluminum cutting blades are the exception, for example, have crack, sound line/hole appear jams distortion, special-shaped with attachments, cutting cutting material of other items.

Treatment plan:

Make sure the problem, according to the different reasons of the corresponding processing.

Second, the feed from abnormal aluminum cutting machine is special carbide saw blade abnormal noise

1, the problem of common cemented carbide saw blades are commonly sliding phenomenon.

Treatment plan:

To adjust the blade

2, aluminum cutting machine spindle stuck

Treatment plan:

According to the actual situation to adjust the spindle

3, after cutting scrap iron stuck in the middle of the road or the front of the material

Treatment plan:

In a timely manner to clean up after cutting scrap iron

Three, cutting the workpiece is not stable, or grain too obvious or too much burr.

1, this usually is because of hard alloy saw blade itself improper handling or saw blades need to be replaced, for example: the matrix effect is unqualified, etc.

Treatment plan:

Replace the saw blade or effect are saw blade

2, sawtooth position profile grinding unqualified cause precision is not enough

Treatment plan:

Replace the saw blade or back to the factory to grinding.

3, cemented carbide in the slice off tooth or iron stuck

Treatment plan:

Tooth that saw blade must be replaced if it is off, back to the factory for replacement, if the iron filings, then clean can.

Above for aluminum cutting machine is special carbide saw blade in the process of using common problems and treatment scheme, for reference only.